Table of Contents
Advertisement
[PICTURE] menu
■
Adjust the waveform
Project the brightness adjustment signal of a commercial
test disk (0% [0 IRE or 7.5 IRE] - 100% [100 IRE] ) and
perform adjustment.
CHANGE WF MODE
MOVE DISPLAY
RETURN
Adjust to 0 %
With COMPUTER (except 1 080
signal) or HDMI (Expand)
Adjust to 0 %
With the [WAVEFORM MONITOR] displayed, press the
<MENU> button on the remote control and adjust using
[ADVANCED MENU] and [PICTURE] from the on-screen
menu.
40 - ENGLISH
1)
2)
Adjust to 100%
Image
displayable
area
Monitor
position
Adjust to 100%
3)
Image
displayable
area
Monitor
position
Adjust [FULL SCAN(Y)] / [SINGLE LINE
SCAN(Y)].
Set on [PICTURE] and use the
z
adjust [BRIGHTNESS] and then [CONTRAST].
Adjust the bottom line of the
waveform to 0 %
[BRIGHTNESS]
(0 or 7.5 IRE)
Setting range:
z
−32 to +32
Adjust the top line of the
waveform to 100 %
[CONTRAST]
(100 IRE)
Setting range:
z
−64 to +64
Adjust [FULL SCAN(R)] / [SINGLE LINE
SCAN(R)].
Set on [ADVANCED MENU] and use the
z
buttons to adjust [BRIGHTNESS R] and then
[CONTRAST R].
Adjust the bottom line of the
waveform to 0 %
[BRIGHTNESS R]
(0 or 7.5 IRE)
Setting range:
z
−16 to +16
Adjust the top line of the
waveform to 100 %
[CONTRAST R]
(100 IRE)
Setting range:
z
−32 to +32
Adjust [FULL SCAN(G)] / [SINGLE LINE
SCAN(G)].
Set on [ADVANCED MENU] and use the
z
buttons to adjust [BRIGHTNESS G] and then
[CONTRAST G].
Adjust the bottom line of the
waveform to 0 %
[BRIGHTNESS G]
(0 or 7.5 IRE)
Setting range:
z
−16 to +16
Adjust the top line of the
waveform to 100 %
[CONTRAST G]
(100 IRE)
Setting range:
z
−32 to +32
buttons to
Advertisement
Table of Contents
