Gpio, Serial (Comm), And Analog Audio Connections; Setting Up 9922-2Fs Network Remote Control - Cobalt Digital Inc 9922-2FS Product Manual

2

GPIO, Serial (COMM), and Analog Audio Connections

Setting Up 9922-2FS Network Remote Control

2-10
Figure 2-2 shows connections to the card multi-pin terminal block connectors.
These connectors are used for card serial comm, GPIO, and balanced analog
audio connections.
Note: It is preferable to wire connections to plugs oriented as shown in
Figure 2-2 rather than assessing orientation on rear module connectors. Note
that the orientation of rear module 3-wire audio connectors is not necessarily
consistent within a rear module, or between different rear modules. If wiring is
first connected to plug oriented as shown here, the electrical orientation will
be correct regardless of rear module connector orientation.
Perform remote control setup in accordance with Cobalt
"Remote Control User Guide" (PN 9000RCS-RM).
Note: • If network remote control is to be used for the frame and the frame has not
yet been set up for remote control, Cobalt
Control User Guide (PN 9000RCS-RM) provides thorough information and
step-by-step instructions for setting up network remote control of Cobalt
cards using DashBoard™. (Cobalt
Remote Control Panel product manuals have complete instructions for
setting up remote control using a Remote Control Panel.)
Download a copy of this guide by clicking on the
Support>Reference Documents link at www.cobaltdigital.com and then
select DashBoard Remote Control Setup Guide as a download, or contact
®
Cobalt as listed in Contact Cobalt Digital Inc. (p. 1-23).
• If installing a card in a frame already equipped for, and connected to
DashBoard™, no network setup is required for the card. The card will be dis-
covered by DashBoard™ and be ready for use.
9922-2FS PRODUCT MANUAL
GPIO, Serial (COMM), and Analog Audio Connections
®
OGCP-9000 and OGCP-9000/CC
®
reference guide
®
reference guide Remote
9922-2FS-OM (V1.8)
®