Table of Contents
Advertisement
2. TOOLS AND PARTS REQUIREMENTS
Required tools:
Electrical drill or ratchet driver
1/2" drill bit for drilling pilot holes
1 ¼" drill bit for drilling electrical wiring
access hole.
Screwdrivers: Philips & Straight blade
Pliers
Tape measure or ruler and pencil
Electrical supplies for wiring
Aluminum tape and/or duct tape
Hammer
Jigsaw or saber saw
Stud finder
Parts Supplied
Range Hood
Chimney
Installation manual
Air Damper
(In bag or already installed) 1 pcs
Exhaust pipe
Hardware bag
Disclaimer: Screws many vary from
model to model.
Parts Supplied
Part
Bracket for
body
Bracket for
upper chimney
Bracket for
lower chimney
Screw: ST4*8
Screw:
ST4.0*30
Wall anchor:
∮8
LOCATION REQUIREMENTS
IMPORTANT: Observe all governing codes and
1 pcs
ordinances. Have a qualified technician install the
2 pcs
range hood. It is the installer's responsibility to comply
1 pcs
with installation clearances specified on the
model/serial rating plate.
1 pcs
Canopy hood's location should be away from strong
1 bag
draft areas, such as windows, doors, and strong
heating vents.
Cabinet opening dimensions that are shown must be
used. Given dimensions provide minimum clearance.
6
QTY
Photo
1pcs
1pcs
1pcs
6pcs
9pcs
9pcs
Advertisement
Table of Contents
