Table of Contents
Advertisement
2. TOOLS AND PARTS REQUIREMENTS
Electrical drill or ratchet driver
1/2" drill bit for drilling pilot holes
1 ¼" drill bit for drilling electrical wiring
access hole.
Screwdrivers: Philips & Straight blade
Pliers
Tape measure or ruler and pencil
Electrical supplies for wiring
Aluminum foils tape and/or duct tape
Hammer
Jigsaw or saber saw
Stud finder
Parts Supplied
Body
Body bracket
Chimney
Chimney mounting bracket
Installation manual
Air outlet
(In bag or on body)
Exhaust pipe
Installation manual
Screw bag
Disclaimer: Screws many vary from
model to model.
Installation parts
Part
Bracket for
body
Bracket for
upper chimney
Bracket for
lower chimney
Screw: ST4*8
Screw:
ST4.0*30
Wall anchor:
LOCATION REQUIREMENTS
1 pcs
IMPORTANT: Observe all governing codes and
1 pcs
ordinances. Have a qualified technician install the
2 pcs
range hood. It is the installer's responsibility to comply
2 pcs
with installation clearances specified on the
1 Set
model/serial rating plate.
Canopy hood's location should be away from strong
1 Set
draft areas, such as windows, doors, and strong
1 Pcs
1 Pcs
heating vents.
1 bag
Cabinet opening dimensions that are shown must be
used. Given dimensions provide minimum clearance.
5
QTY
Photo
1pcs
1pcs
1pcs
4pcs
9pcs
9pcs
Advertisement
Table of Contents
