Table of Contents
Advertisement
Installing and Composition
Installing and Composition
Installation Instructions
* Don't place the projector in the following conditions. It may cause malfunction or product damage.
Provide proper ventilation for this projector.
The projector is equipped with ventilation holes(intake) on
the bottom and ventilation holes(exhaust) on the front. Do
not block or place anything near these holes, or internal
heat build-up may occur, causing picture degradation or
damage to the projector.
Never push projector or spill any kind of liquid into the
projector.
Place this projector in adequate temperature and humidity conditions.
Install this projector only in a location where adequate temperature and humidity is available. (refer p.41)
Don't place the projector where it can be covered with dust.
This may cause overheating of the projector.
Do not obstruct the slots and openings of the projector. This may cause overheating and create a fire hazard.
The projector is manufactured using high-precision technology. You may, however, see tiny black points and/or
bright points (red, blue, or green) that continuously appear on the projector Screen. This is a normal result of
the manufacturing process and does not indicate a malfunction.
To display DTV programs, it is necessary to purchase a DTV receiver (Set-top Box) and connect it to the projec-
tor.
When the remote control does not work during operation.
The remote control may not work when a lamp equipped with electronic ballast or a three-wavelength lamp is installed.
Replace those lamps with international standard products to use the remote control normally.
13
Do not place the projector on a carpet, rug or other
similar surface. It may prevent a adequate ventilation
of the projector bottom. This product should be
mounted to a wall or ceiling only.
Leave an adequate distance(30cm/12 inches or
more) around the projector.
Advertisement
Table of Contents
