Changing The Needle; Fabric And Needle Chart - Janome JW8100 Instruction Book

q
Fabric
Lawn
Georgette Silk #80-100
Fine Tricot Cotton #80-100
Organza Synthetic #80-100
Crepe
Sheeting
Silk #50
Jersey
Medium Cotton #50-80
Broadcloth
Synthetic #50-80
Fleece
Denim
Silk #30-50
Heavy Tweed
Cotton #40-50
weight Coating
Synthetic #40-50
Quilting
NOTE:
3 x #14/90 needles are included in the envelop.
(Part No. 639804000).
w
Thread Needle
#9/65-11/75
#11/75-14/90
#14/90-16/100

Changing the Needle

CAUTION:
Turn OFF the power switch before changing the
needle.
Raise the needle to its highest position by turning the
handwheel counterclockwise, and lower the presser
foot.
Loosen the needle clamp screw by turning it
counterclockwise. Remove the needle from the needle
clamp.
Insert a new needle into the needle clamp with the flat
side to the rear. When inserting the needle into the
needle clamp, push it up as far as it will go.
Tighten the needle clamp screw firmly by turning it
clockwise.
q Needle clamp screw
w Flat side
To see if the needle is in good condition, place the flat
side of the needle onto something flat (needle plate, glass
etc.). The gap between the needle and the flat surface
should be consistent. Never use a bent or blunt needle.
A damaged needle can cause permanent snags or runs
in knits, fine silks and silk-like fabrics.

Fabric and Needle Chart

• For general sewing, use needle size 11/75 or 14/90.
• A fine thread and needle should be used for sewing
lightweight fabrics, so the fabric will not be marred.
• Heavy fabrics require a needle large enough to pierce
the fabric without fraying the needle thread.
• Always test the needle size on a small scrap of the
fabric that will be used for actual sewing.
• In general, use the same thread for the needle and
bobbin.
NOTE:
When sewing stretch fabrics, very fine fabrics and
synthetics, use a blue tip needle (Part No. 990311000,
sold separately). The blue tip needle effectively
prevents skipped stitches.
13