Janome JW8100 Instruction Book page 33

n
!3
m
,
q
q
!4
y
w
e
w
e
n
The buttonhole is sewn in the sequence as shown.
automatically with the needle in the up position.
m
Remove the fabric and place a pin just below the
bartack to prevent accidentally cutting the stitches.
Cut the opening with the seam ripper.
!3 Pin
!4 Seam ripper
,
buttonhole lever upward as far as it will go.
y
Buttonhole lever
Double layer buttonhole
To make a sturdy buttonhole, sew another layer of
buttonhole stitches over the previous stitches.
buttonhole lever, simply start the machine again.
NOTE:
If the fabric is not feeding smoothly when sewing
a double layer buttonhole, increase the buttonhole
density.
Altering the buttonhole width
Press the mode key q
the stitch width value.
Press the "+" sign on the value set key to increase the
buttonhole width.
Press the "–" sign on the value set key to decrease the
buttonhole width.
q
Mode key
w
Cursor
e
Value set key
NOTE:
The buttonhole width can be adjusted from 2.5 to 7.0.
Altering the buttonhole density
Press the mode key q
the stitch length value.
Press the "+" sign on the value set key to decrease the
buttonhole density.
Press the "–" sign on the value set key to increase the
buttonhole density.
q
Mode key
w
Cursor
e
Value set key
NOTE:
The buttonhole density can be adjusted from 0.2 to 0.8.
31
until the cursor w
appears under
until the cursor w
appears under