Cedar Ridge CRHQD250T Owner's Operation And Installation Manual page 21

Use a vacuum cleaner, pressurized air, or a
small, soft bristled brush to clean.
A yellow tip on the pilot flame indicates dust
and dirt in the pilot assembly. There is a small
pilot air inlet hole about 2" from where the
pilot flame comes out of the pilot assembly
(see Figure 23). With the unit off, lightly blow
air through the air inlet hole. You may blow
through a drinking straw if compressed air is
not available.
CABINET
Air Passageways
Use a vacuum cleaner or pressurized air to
clean.
Exterior
• Use a soft cloth dampened with a mild soap
and water mixture.
• Wipe the cabinet to remove dust.
200029-01A
CARE AND MAINTENANCE
ODS/PILOT
www.usaprocom.com
Natural Gas
Burner
Pilot Air
Inlet Hole
Figure 23 - Pilot Inlet Air Hole
LOGS
• If you remove logs for cleaning, refer to
Installing Logs, page 16, to properly replace
logs.
• Replace log(s) if broken or chipped (dime-
size or larger).
Propane/LP
Gas Burner
Pilot Air Inlet Hole
21