Specifications - Makita HR3541FCX Instruction Manual

ENGLISH (Original instructions)
1. Switch trigger
2. Lamp
3. Adjusting dial
4. Lock button
5. Pointer
6. Change lever

SPECIFICATIONS

Concrete
Capacities
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for hammer drilling in brick, concrete
and stone as well as for chiselling work.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.
ROTARY HAMMER SAFETY
WARNINGS
1. Wear ear protectors. Exposure to noise can cause
hearing loss.
2. Use auxiliary handle(s), if supplied with the tool.
Loss of control can cause personal injury.
3. Hold power tool by insulated gripping surfaces,
when performing an operation where the cutting
Explanation of general view
7. Power-ON indicator lamp (green)
8. Service indicator lamp (red)
9. Side grip
10. Bit shank
11. Bit grease
12. Bit
Model
Tungsten-carbide tipped bit
Core bit
Steel
Wood
-1
)
Blows per minute
Overall length
Net weight
Safety class
accessory may contact hidden wiring or its own
ENE044-1
cord. Cutting accessory contacting a "live" wire may
make exposed metal parts of the power tool "live" and
could give the operator an electric shock.
ENF002-1
4. Wear a hard hat (safety helmet), safety glasses
and/or face shield. Ordinary eye or sun glasses
are NOT safety glasses. It is also highly
recommended that you wear a dust mask and
thickly padded gloves.
5. Be sure the bit is secured in place before
operation.
6. Under normal operation, the tool is designed to
produce vibration. The screws can come loose
GEA010-1
easily, causing a breakdown or accident.
Check tightness of screws carefully before
operation.
7. In cold weather or when the tool has not been
used for a long time, let the tool warm up for a
while by operating it under no load. This will
loosen up the lubrication. Without proper warm-
up, hammering operation is difficult.
8. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
GEB007-7
9. Hold the tool firmly with both hands.
10. Keep hands away from moving parts.
11. Do not leave the tool running. Operate the tool
only when hand-held.
12. Do not point the tool at any one in the area when
operating. The bit could fly out and injure
someone seriously.
13. Chuck cover
14. Depth gauge
15. Clamp screw
16. Blow-out bulb
HR3540C
35 mm
90 mm
13 mm
32 mm
315 - 630
1,650 - 3,300
439 mm
5.2 kg
/II
HR3541FC
5.6 kg
5