Table of Contents
Advertisement
4.1 Connection to LPG
Use a pressure regulator and make the connection to the tank according to the
provisions of standards regulations in force. Make sure that feed pressure conforms to
the levels shown in the table in Section "5.2 Regulation for LPG ".
4.2 Ventilation of rooms
The hob may be installed only in rooms with permanent ventilation, as required by
standards regulations in force. The room in which the hob is installed must have
sufficient air flow to satisfy the requirements of normal gas combustion and of
necessary air exchange in the room. The air intakes, protected by screens, must be
appropriately sized (regulations in force) and placed so as not to be blocked in any
way.
The room where the oven is installed should be suitably ventilated to avoid
overheating or excess humidity produced by cooking, and in the case of lengthy use a
window should be opened or the speed of any ventilators should be increased.
4.3 Discharge of combustion products
Discharge of combustion products must be guaranteed by means of hoods connected
to a natural draught flue with certain efficiency, or by means of forced aspiration.
An efficient aspiration system requires careful planning by a specialist capable of
installing it, respecting the positions and distances prescribed by standards. After
installation, the installer must issue a certificate of conformity.
24
Instructions for the installer
Advertisement
Table of Contents
