User Interface Setup - Kenwood DDX6904S Instruction Manual

Setting Up

User Interface Setup

You can setup user interface parameters.
1
Press the [ ] button.
h Popup menu appears.
h
2
Touch [SETUP].
h SETUP screen appears.
h
3
Touch [User Interface].
h User Interface screen appears. h
4
Set each item as follows.
Beep
■
Turns the key touch tone on or off.
Default is "ON".
Parking Assist Display
■
When an ADS adapter is connected, you can
display information about obstacles around
the car.
ON: Always displays information.
Dyn. (Default): Displays information when
the sensor detects obstacles.
OFF: Cancels.
This can be set when the iDataLink
(commercially available) is connected.
Parking Assist Position
■
Select where information about obstacles is
displayed on the screen (left or right).
"Left"/ "Right" (Default)
This can be set when the iDataLink
(commercially available) is connected.
Language Select
■
Selects a language.
Touch Panel Adjust
■
Adjust the sensing position of touch panel.
(P.68)
Clock
■
GPS-SYNC (Default): Synchronizes the clock
time with the GPS.
Manual: Sets the clock manually
Time Zone
■
If you select [Manual] for Clock, select the
time zone.
68
Clock Adjust
■
If you select [Manual] for Clock, adjust the
date and time manually. (P.68)
Ñ
Adjust the date and time
manually.
1
Touch [Clock] in the User Interface screen.
2
Touch [Manual].
3
Touch [Time Zone] in the User Interface
screen.
4
Select the time zone.
5
Touch [Clock Adjust] in the User Interface
screen.
6
Adjust the date, then adjust the time.
7
Touch [Set].
Ñ
Touch panel adjustment
1
Touch [Touch Panel Adjust] on the User
Interface screen.
h Touch Panel Adjust screen appears.
h
2
Follow the instruction on the screen and
long touch the center of each [
1
NOTE
• To cancel the touch panel adjustment, touch
[Cancel].
• To reset to the initial status, touch [Reset].
].
2