Setup; Settings - Kenwood KMR-XM500 Instruction Manual

Setup

Settings

1
Press and hold <
2
Press <E>/<F> to select the category.
3
Turn the volume knob to select an item (see the
following table), then press the knob.
4
Repeat step 3 until the desired item is selected/
activated or follow the instructions stated on
the selected item.
5
Press < >.
Audio Settings
Fader F12 — R12 (F0/R0): Adjusts the front
and rear speaker output balance.
Balance L12 — R12 (L0/R0): Adjusts the left and
right speaker output balance.
Graphic Selects a preset equalizer suitable to the
Equalizer music genre.
Flat / Hard Rock / Classical / Pop / Dance
/ Electronic / Hip Hop / User
Select [User] to use the settings made
1) Press the volume knob to select the
frequency.
2) Turn the volume knob to adjust the
level.
3) Press <
Loudness Sets the amounts of boost of low and
high tones.
"ON", "OFF" (Default)
X'over You can set the crossover frequency of
speakers.
1) Press <E>/<F> to select the
speaker.
2) Press the volume knob to select the
item.
3) Turn the volume knob to adjust the
value.
4) Press <
12
> to display the settings.
>.
>.
General Settings
Bluetooth Settings
Discoverable Enable (Default)/Disable: Set
whether to pair or not.
Device Name The Bluetooth device name of this
unit is displayed.
(P.3)