Installation - AEG A51110HSW0 User Manual

24 www.aeg.com
Problem
8.1 Customer Service
If your appliance is still not working
properly after making the above checks,
contact the nearest service centre.
To obtain fast service, it is essential that
when you apply for it you specify the

9. INSTALLATION

9.1 Positioning
WARNING!
If you are discarding an old appli-
ance that has a lock or catch on
the lid, you must ensure that it is
made unusable to prevent young
children being trapped inside.
The appliance shall have the
plug accessible after installation.
This appliance can be installed in a dry,
well ventilated indoor (garage or cellar),
but for optimum performance install this
appliance at a location where the ambi-
ent temperature corresponds to the cli-
mate class indicated on the rating plate
of the appliance:
Cli-
mate
class
SN
N
ST
T
Possible cause
Power does not reach the
appliance
The appliance is not
switched on
The thermostatic control
is not on
There is no voltage in the
mains socket (try to con-
nect another appliance
into it)
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
Solution
Try connecting another
electrical device to the
power outlet
Switch on the appliance
Check setting of thermo-
static control
Call an electrician
model and serial number of your appli-
ance which can be found either on the
guarantee certificate or on the rating
plate located on the external right side
of the appliance.
9.2 Electrical connection
Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic pow-
er supply.
The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the do-
mestic power supply socket is not earth-
ed, connect the appliance to a separate
earth in compliance with current regula-
tions, consulting a qualified electrician.
The manufacturer declines all responsi-
bility if the above safety precautions are
not observed.
This appliance complies with the E.E.C.
Directives.
9.3 Ventilation requirements
1. Put the freezer in horizontal position
on a firm surface. The cabinet must
be on all four feet.
2.
Make sure that the clearance be-
tween the appliance and rear wall is
5 cm.