Step 23: Replace Toekick; Step 24: Check The Following - GE PDT855SSJSS Installation Instructions Manual

Dishwasher Installation
STEP 22: POSITION SOUND INSULATION
PIECE (on some models)
• Locate the sound insulation package inside the dishwasher.
• Stand the parts upright as shown.
Dishwasher
Door
Toekick
Figure AF
• Locate the control box.
Figure AG
• Push insulation block portion under the dishwasher until it is
beneath the control box.
• Push the panel portion up to the front of the block.
(on some models)
Push the sides of the insulation behind
the toekick attachment screw holes
• Tuck the sides of the front panel behind the toekick
attachment screw holes.
• Open door all the way, if the door doesn't stay fully open,
• Align the screw holes with the screw holes on the legs of the
dishwasher.
• Ensure vent opening is not blocked by insulation.
Vent opening
Location and appearance will vary
Insulation Block
(On some models.)
Control Box
Figure AH

STEP 23: REPLACE TOEKICK

• Place toekick against the legs of the dishwasher.
Attachment
Figure AH
• Align the toekick with the bottom edge and make sure it is
• Insert and tighten the 2 toekick attachment screws. The
Tip: Reduce sound from under the dishwasher. Make sure
toekick is against floor.

STEP 24: CHECK THE FOLLOWING

• Tub trim does not interfere with the door
• Dishwasher is square and level at both the top and bottom of
the cabinet opening, with no twisting or distortion of the tub
or door
• Drain hose is not pinched between the dishwasher and
STEP 25: LITERATURE
• Be sure to leave complete literature package, these
Installation Instructions and product samples and/or coupons
with the consumer.
T o e k i c k
Screws
15