Step 20: Dishwasher Wet Test - GE PDT855SSJSS Installation Instructions Manual

Dishwasher Installation

STEP 20: DISHWASHER WET TEST

• Turn on power supply or plug power cord into outlet,
if equipped.
• Select a cycle to run and push the Start button.
• Ensure the door is latched. Dishwasher should start.
• Check to be sure that water enters the dishwasher. If water
does not enter the dishwasher, check to be sure that water
and power are turned on.
• Check for leaks under the dishwasher. If a leak is found, turn
off power at the breaker, and then tighten water connections.
Restore power after leak is corrected.
• Check for leaks around the door. A leak around the door could
be caused by door rubbing or hitting against
See Step 13.
• Press and hold the Start button for 3 seconds to cancel
the cycle. The unit will begin to drain. Check drain lines. If
leaks are found, turn off power at the breaker and correct
plumbing as necessary. Restore power after corrections are
made. See Steps 7, 8, 9, 10 and 17.
• Open dishwasher door and make sure all of the water has
drained. If not, check that disposer plug has been removed
and/or air gap is not plugged. Also check drain hose to be
sure it is not kinked underneath or behind dishwasher. See
Step 17.
• Press Start button once again and run dishwasher through
another cycle. Check for leaks and correct if required.
• Repeat this step as necessary.
14
STEP 21: REPLACE FLOOR PROTECT PAN
(on some models)
lock slots are close to engaging the side mounting tabs on
the dishwasher.
• Lift the pan until its lock slots contact the mounting tabs and
push the pan back to engage them.
Two on each side
of the dishwasher
Rear
Floor Protect Pan
• When properly installed, the top of the lock slots will be over
the mounting tabs.
• Connect the leak sensor connector to the leak sensor
(on some models).
Leak Sensor
(on some models)
Floor Protect Pan
Figure AE
Mounting Tab
Lock Slots
Two on each side of
the floor protect pan
Front
Mounting
Tab
Lock Slot