Electrolux EWF1142BDWA User Manual page 38

38 www.electrolux.com.cn
Fitting Hose Guide
1.
Pull apart to
insert hose.
2.
In this case, make sure the end cannot
come unhooked when the machine will
be emptied. This could be done by tying
it to the tap with a piece of string or
attaching it to the wall.
Hose
Guide
pull hose
Adjust length to suit
trough.
● In a sink, drain pipe branch.
This branch must be above the trap so
that the bend is at least 60 cm above
the ground.
bend
hose
Max.
90 cm
Min.
60 cm
Push the drain hose onto the spigot
and secure with a clamp, ensure a
loop is formed in the drain hose to
prevent waste from the sink entering
the appliance.
● Directly into a drain pipe, at a height
of not less than 60 cm and not more
than 90 cm.
The end of the drain hose must
always be ventilated, i.e. the inside
diameter of the drain pipe must be
larger than the outside diameter of the
drain hose.
The drain hose must not be twisted or
curled. Run it along the floor; only the
part near the drainage point must be
raised.
For the correct functioning of the
machine, the drain hose must remain
hooked on the proper support piece
situated on the top part of back side of
the appliance.
Max. 90 cm
Min. 60 cm