Starting A Cycle ( ); Interruption Of A Program; Changing A Program; Changing The Options - Electrolux EWF1142BDWA User Manual

Table of Contents

Advertisement

20
www.electrolux.com.cn
5.4 Starting A Cycle (
To start a program, press the Start/Pause
touchpad. The corresponding pilot light
will stop flashing and a default program
duration will be displayed on the screen.
After approx. 15 minutes from the start of
a program:
− T he appliance will automatically
adjust the selected program duration
according to the type and size of the
load.
− T he display will show adjusted
program duration.
NOTE
If you press any touchpad while a
program is operating, the symbol "" will
flash on display along with buzzer sound.
(except Start/Pause touchpad and On/
Off button)

5.5 Interruption Of A Program

− T o pause, press Start/ Pause. The
indicator will start flashing.
− P ress the Start/Pause again. The
program will continue.

5.6 Changing A Program

Changing a running program is possible
only by switching off the appliance.
− P ress the "On/Off" button to cancel the
program and to turn off the appliance.
− P ress the "On/Off" button again to
start the appliance.
Now you can set a new wash program
and change any available options. Press
Start/Pause to start the new program.
NOTE
The appliance will not drain the water
(except programs; Vapour Refresh, Spin,
Rinse + Spin, Tub Clean).

5.7 Changing The Options

)
It may be possible to change some of the
options after a wash program has started.
1. Press the touchpad Start/Pause. The
indicator will start flashing.
2. If available change the options that
you wish.
3. Press Start/Pause again. The program
will continue.

5.8 Opening The Door

While a program or the Delay End is
operating, the appliance door is locked
and the display shows the indicator "
". First, set the machine to PAUSE
by pressing the "Start/Pause" touchpad.
Wait until the door lock indicator goes off,
then the door can be opened.
If the door lock indicator "
disappear, this means that the machine
is already heating and the water level
is above the bottom edge of the door or
the drum is turning. In this case the door
CAN NOT be opened. If you need to
open it, you must drain the water to open
the door.
In case of emergency please
refer to "Emergency door
opening" on page 33.
" does not

Advertisement

Chapters

Table of Contents
loading

Table of Contents