Tripp Lite PDU3VS6L2120 Owner's Manual page 14

i
Using the Digital Display
Rotating the Display
0 3.0
0 i
Features
C13
Outlet Status LED
Push-to-Reset Guard
18-11-311-9332D2.indb 14
Outlets: During normal operation, the outlets
distribute AC power to connected equipment.
C19
Outlet Status LED: Once the unit is powered on, each outlet individually
ramps up and each Outlet Status LED will illuminate when the associated
outlet is ready to distribute live AC power.
LED Color Outlet Status
Green On
Yellow On
Red Off
Flashing Red Off
Off Off
Note: Colors noted here reflect standard LED configuration. See chart on page 13
for full LED color definitions.
Circuit Breaker (Select Models): There are 3 Load Banks, each
protected by a circuit breaker. If the connected equipment load exceeds
the Maximum Load Rating for those banks of the PDU, the circuit breaker
will trip. Disconnect excess load and reset the breaker.
Note: Each breaker comes equipped with a push-to-reset guard to prevent
accidental breaker tripping. To turn off the breaker, insert a flathead screwdriver into
the reset slot.
Mounting Brackets: Use these brackets as an alternate PDU mounting
method.
Mounting Buttons: Come pre-installed on the back side of the PDU and
are used for toolless mounting. Note: Four additional mounting buttons
are included for alternate rack styles.
14
At any point, pressing both of the arrow
buttons simultaneously and holding
for 3 seconds rotates the 2-digit and
3-digit displays.
Comments/Notes
Normal operation.
Outlet bank's current has exceeded 80% of its
current rating.
Outlet bank's voltage is below the Low Voltage
threshold.
Circuit breaker for this bank has tripped.
Outlet is powered off.
1/23/2019 6:19:44 PM