COMFORT-AIRE Century PTTC09B-1 Owner's Manual page 13

Owner's Manual - PTTC/PTTE/PTTH-09/12B-1
Notice:
● When power is connected (stand by condition), you can operate the air conditioner
through the remote controller.
● When unit is on, each time you press the button on remote controller, the sending signal
icon " " on the display of remote controller will blink once. If the air conditioner gives
out a beep sound, it means the signal has been received.
● When unit is off, set temperature will be displayed on the remote controller (If the light of
indoor unit display is turned on, the corresponding icon will be displayed). When the
unit is on, it will display the icon of the ongoing function.
● This is a general use remote controller, it could be used for the air conditioners with
multifunction. For functions your model does not have, press the corresponding button
on the remote controller and the unit will keep the original running status.
1
ON/OFF button
Press this button to turn unit on/off.
2
MODE button
Pressing this button once will select your required mode circularly as below (the corresp-
onding icon " " will be lit up after the mode is selected):
AUTO
● When selecting auto mode, air conditioner will operate automatically according to amb-
ient temperature. Set temperature can't be adjusted and won't be displayed either. Press
FAN button to adjust fan speed.
● When selecting cool mode, air conditioner will operate under cool mode. Then press +
or - button to adjust set temperature. Press FAN button to adjust fan speed.
● When selecting dry mode, air conditioner will operate at low fan speed under dry mode.
In dry mode, fan speed can't be adjusted.
● When selecting fan mode, air conditioner will operate in fan mode only. Press the FAN
button to adjust fan speed.
● When selecting heat mode, air conditioner will operate under heat mode. Press + or -
button to adjust set temperature. Press FAN button to adjust fan speed.
(Cooling only unit can't receive heating mode signal. If HEAT mode is set by remote
controller, pressing the ON/OFF button cannot turn on the air conditioner.)
Note: The unit can only receive the signal for cool/fan/heat and it has no action when
receiving the signal of other modes.
3
+ / - button
● Pressing + or - button once will increase or decrease set temperature by 1°F(°C). Hold +
or - button for 2s, set temperature on remote controller will change quickly. Release the
button after your required set temperature is reached.
● When setting Timer On or Timer Off, press + or - button to adjust the time. (See TIMER
Button for setting details)
COOL DRY FAN HEAT (Only for models with heating function.)
-10-
13