Table of Contents
Advertisement
Available languages
Available languages
Tools and Parts
Tools Needed
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
■
Cordless drill
¹⁄₁₆" and ³⁄₈" brad point
■
doweling drill bit
■
Phillips screwdriver
■
Rotary tool
Parts Needed
■
Custom Overlay Frame—See "Overlay Frame—Rear
View."
Parts Supplied
■
Flat-head screws (TRUSS M4x34 Tapping) (8)
Location Requirements
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from beverage center.
Failure to do so can result in death, explosion, or fire.
To ensure proper ventilation for your beverage center, allow for a
¹⁄₄" (6.35 mm) space on each side and at the top. When installing
your beverage center next to a fixed wall, leave 2¹⁄₂" (6.35 cm)
minimum clearance on the hinge side to allow for the door to
swing open.
NOTE: It is recommended that you do not install the beverage
center near an oven, radiator, or other heat source. Do not install
in a location where the temperature will fall below 55°F (13°C). For
best performance, do not install the beverage center behind a
cabinet door or block the base grille.
¹⁄₄
" (6.35 mm)
4
INSTALLATION REQUIREMENTS
■
Scissors
■
C-clamp
■
Masking tape
■
Tape measure
■
Petroleum jelly
¹⁄₂
2
" (6.35 cm)
Opening Dimensions
■
Height dimensions are shown with the leveling legs extended
to the minimum height.
NOTE: When leveling legs are fully extended, add ⁵⁄₈" (15 mm)
to the height dimensions.
■
If the floor of the opening is not level with the kitchen floor,
shim the opening to make it level with the kitchen floor.
³⁄₄
14
"
(37.5 cm)
A
¹⁄₂
"
(1.3 cm)
24"
(60.96 cm)
min.
24" (60.96 cm) min.
Critical Dimensions:
³⁄₄
A. 14
" (37.5 cm) utility opening
B. 24" (60.96 cm) minimum opening width
Custom Overlay Frame
If you plan to install a custom overlay frame, you will need to
create the frame yourself or consult a qualified cabinetmaker or
carpenter. See dimension drawings for frame specifications.
IMPORTANT:
The thickness of the overlay frame must be ³⁄₄" (19 mm).
■
■
The overlay frame must not weigh more than 10 lbs (4.54 kg).
Overlay frames weighing more than recommended may
cause damage to your appliance.
■
Overlay frame drawings show the rear view of the frame.
Overlay Frame Dimensions—Rear View
1. Create a custom overlay frame using the dimensions shown.
2. Rout four depressions into the overlay frame, where
indicated, to attach the overlay hooks.
NOTE: To inlay the overlay hooks into the frame, it is
recommended that you use a rotary tool to rout the surface
where the overlay hooks will be placed.
³⁄₈
34
" (87.3 cm) min.
35" (88.9 cm) max.
B
Advertisement
Table of Contents
