Clock Functions Table; Setting The Duration - Zanussi ZOF35802XK User Manual

Symbol
Moist Baking
CLOCK FUNCTIONS

CLOCK FUNCTIONS TABLE

Clock function
TIME OF DAY
DURATION
END
TIME DELAY
MINUTE MINDER
SETTING THE TIME. CHANGING THE TIME
You must set the time before you operate the oven.
Only the top oven works without the
set time.
The flashes when you connect the appliance to
the electrical supply, when there was a power cut
or when the timer is not set.
Press the or to set the correct time.
After approximately five seconds, the flashing stops
and the display shows the time of day you set.
To change the time of day press
again until starts to flash.
8
Oven function
To set, change or check the time of day.
To set how long the appliance operates.
To set when the appliance deactivates.
To combine DURATION and END function.
To set countdown time. This function has no effect on the opera-
tion of the appliance. You can set the MINUTE MINDER at any
time, also when the appliance is off.
again and
Application
This function is designed to save energy during cooking.
For the cooking instructions refer to "Hints and tips"
chapter, Moist Baking. The oven door should be closed
during cooking so that the function is not interrupted and
to ensure that the oven operates with the highest energy
efficiency possible. When you use this function, the tem-
perature in the cavity may differ from the set temperature.
The heating power may be reduced. For general energy
saving recommendations refer to "Energy Efficiency"
chapter, Energy Saving.This function was used to comply
with the energy efficiency class according to EN
60350-1. When you use this function the lamp automati-
cally turns off.
Application

SETTING THE DURATION

1. Set an oven function and temperature.
2. Press again and again until
flash.
3. Press or
The display shows
4. When the time ends,
acoustic signal sounds. The appliance
deactivates automatically.
5. Press any button to stop the acoustic signal.
6. Turn the knob for the oven functions and the
knob for the temperature to the off position.
starts to
to set the DURATION time.
.
flashes and an