Table of Contents
Advertisement
Model 8335 (TC/SYNC card) Owner's Manual
4. Time code output ON/OFF setup at pause [PA US tc 403 -***]
Whether time code should be output or not in the PAUSE mode of D-15 is
selected by this menu.
After entering the SETUP mode, rotate the [JOG] dial, select the [PAUStc 403
-***] menu, and press the [EXECUTE/SET] key. Then, after rotating the [JOG]
dial CW and CCW to select the desired frame rate, press the [EXECUTE/SET]
key again (* is the initial setting).
This setup content will be held even though power is switched OFF.
Functional note
Menu No.
OFF
403
ON
403
5. Setup of time code output at fast winding [Wi nd tc 404 -***]
Whether time code should be output or not in the fast wind mode of F FWD/
REWIND of D-15 is selected by this menu.
After entering the SETUP mode, rotate the [JOG] dial, select the [Windtc 404 -
***] menu, and press the [EXECUTE/SET] key. Then, after rotating the [JOG]
dial CW and CCW to select the desired frame rate, press the [EXECUTE/SET]
key again (* is the initial setting).
This setup content will be held even though power is switched OFF.
Functional note
Menu No.
1 Fr AM
404
5 Fr AM
404
Stop
404
Setup No.
Functional content
000 (*)
PAUSE TC OFF (TC not output)
001
PAUSE TC ON (The read out time code
is repeatedly out put in complete units of
hour, minute, second and frame)
Setup No.
Functional content
000 (*)
The read out time code is output in
complete units of hour, minute, second
and frame units.
001
The read out time code in complete units
of hour, minute, second and frame, and
in addition four frames are pseudo
attached for a total of 5 frames in the
positive direction are converted to a
continuous time code and output.
002
Time code will not be output in other than
the PLAY and REC modes.
12
Advertisement
Table of Contents
