Advertisement
Problem
Vacuum sealer bag loses
vacuum after being sealed
Vacuum sealer not sealing
bag properly
The canisters and bowl will
not vacuum
Possible Cause
1. Bag not sealed properly.
2. Moisture or juices from
foods.
3. Bag has a hole.
1. Sealing strip is too hot.
2. Seal Only function still active
or needs to reset.
1. Lower & Upper gaskets are
not forming an air tight seal.
2. Canister lid dial not in SEAL
position.
3. Accessory hose not correctly
attached to Vacuum Seal
Hose Port or canister lid.
Solution
1. Wrinkles, crumbs, grease or liquids may cause leaks along the
seal. Reopen bag, wipe the top inside of the bag and smooth it out
along the sealing strip before resealing.
2. Check if there is moisture or juices from the food present within
the bag, if yes, you may need to cut open the bag and reseal it,
or use an entirely new bag. Foods with excess liquids should be
frozen before vacuum sealing.
3. Items with sharp edges may have punctured the bag, releasing the
vacuum. Cushion sharp edges in the contents of the bag with paper
towels.
1. The sealing strip may have overheated and melted the bag. Lift the
lid and allow sealing strip to cool for a few minutes.
2. Before re-pressing the "seal only" button, allow the unit to resume
for 15 seconds.
1. Ensure Gaskets are correctly sealed and are not compressed. See
page 15 for further information on Gaskets.
2. Gently turn the canister lid dial arrow to SEAL position.
3. Make sure accessory hose is firmly pushed in all the way into
Vacuum Seal Hose Port on appliance and canister lid.
INSTALLATION AND OPERATING INSTRUCTIONS 23
Advertisement
