Samsung NX58F5500SB User Manual page 62

Troubleshooting
PROBLEM POSSIBLE CAUSE
Surface burner The control knob has been left
clicks during in the LITE position.
operation.
The burners Surface burner components
do not burn and caps are not assembled
evenly. correctly and level.
Surface burners are dirty.
Wrong orifice is assembled.
Very large or
yellow surface
burner flames.
62 English
NX58F5300SS_AA_DG68-00509A-06_EN+MES.indb 62
SOLUTION
After the burner lights, turn Surface
the control knob to a desired burners light
setting. but oven
burners do not
If the burner still clicks,
light.
contact a service technician.
See page 51.
Clean surface burner
Display goes
components. (See pages 51
blank.
and 53.)
Contact your installer. Check
the burner orifice size and
contact your installer if you
have the wrong orifice. Check
Very large or
the LP gas conversion.
yellow oven
burner flames.
PROBLEM POSSIBLE CAUSE
The oven door lock is turned
on.
Gas Pressure Regulator
shut off switch is in the 'off
position.
The electrical outlet Ground
Fault Interrupter (GFI or GFCI)
has been tripped and needs to
be reset.
Your digital control has been
damaged.
The oven burner air
adjustment shutters need to
be adjusted.
Gas supply is not properly
connected or turned on.
SOLUTION
The display will show the
Lock icon. Hold the oven door
open and press the START/
SET pad for 3 seconds. The
oven will beep and the Lock
icon will turn off.
Call a qualified service
technician.
Replace fuse or reset circuit
breaker.
Call for a qualified service
technician.
See the Installation
Instructions that came with
your range.
2018-08-30 12:07:33