More About Your Advanced Water Filter; Nsf Tests & Certification Results; To Replace Your Pureadvantage; Tm Water Filter - Electrolux EI23SS55 Use And Care Manual

More about your advanced water filter

The PureAdvantage
filter system is tested and certified
by NSF International, the nationally
respected, not-for-profit certification
organization for public health safety.
The PureAdvantage ice and water filter system
TM
is tested and certified to ANSI/NSF Standards 42
and 53 for the reduction of claims specified on the
performance data sheet.
Do not use with water that is microbiologically
unsafe or of unknown quality without adequate
disinfection before or after the system. Systems
certified for cyst reduction may be used on
disinfected waters that may contain filterable cysts.
NSF test & certification results:
• Rated Capacity - 400 gallons for
PureAdvantage ice and water filter
TM
• Rated service flow - .5 gallons per minute
• Maximum Rated Pressure - 100 pounds per
square inch
• Operating Temp.: Min. 33° F, Max. 100° F
• Recommended Minimum Operating
Pressure: 30 pounds per square inch

To replace your PureAdvantage

filter:
It is not necessary to turn the water supply off
to change the filter. Be ready to wipe up any
small amounts of water released during the filter
replacement.
1 Turn Off the ice maker power switch.
2 Push the filter release button below the
cartridge to disconnect it.
3 Slide the old water filter cartridge straight out
of the housing and discard it.
4 Unpackage the new filter cartridge and slide
it gently into the filter housing until it stops
against the snap-in connector at the back of
the housing.
5 Push firmly until the cartridge snaps
into place (you should hear a click as the
cartridge engages the snap-in connector).
When fully engaged, the front of the filter
cartridge should be flush with the filter
release button.
Changing The Filter
6 Press a drinking glass against the water
ice and water
TM
7 After filling one glass of water, continue
8 Turn On the ice maker power switch (see
9 Press and hold the Filter Status button on
water
TM
dispenser while checking for any leaks at the
filter housing. Any spurts and sputters that
occur as the system purges air out of the
dispenser system are normal.
flushing the system for about three minutes.
page 18 for more about turning on the ice
maker).
the Ice & water Dispenser control panel for
three seconds. When the display changes
from "Replace" to "Good," the status has
been reset.
21