Table of Contents
Advertisement
Non-Adjusting Hinge (some models)
3 Remove the two bottom hinge screws and
hinge if necessary.
To reinstall the refrigerator door, reverse the above
steps.
CAUTION
Be sure doors are set aside in a secure
position where they cannot fall and cause
personal injury.
To remove the freezer top hinge cover:
1 Remove the two screws from each cover
over the top door hinges.
2 Lift hinge cover straight up and off.
To remove the freezer door:
1 Detach the multi-wire cable connector
located above the top hinge. Grasp both
sides of the connector firmly and pull apart.
Removing The Doors
2 Trace lightly around the hinge with a pencil.
This makes reinstallation easier.
3 Detach the water tube from the connector
located below the freezer door. The
connector releases when you press its outer
sleeve inward.
Adjustable Hinge (some models)
Non-Adjusting Hinge (some models)
4 Remove the screws from the top hinge and
pull the multi-wire cable through it. Lift the
door off of the bottom hinge.
5 Remove the two bottom hinge screws and
hinge if necessary.
6 Lay the door on its side to avoid damage to
the water tube extending from the bottom
hinge.
To reinstall the freezer door, reverse the above
steps.
Once both doors are in place, ensure they are
aligned with each other and level (Please see "To
level the doors using the lower hinge" for models
with adjustable lower hinges or "To level the
cabinet using the front rollers" for models with the
non-adjustable lower hinges in the "Installation"
section.), then replace the top hinge cover.
7
Advertisement
Table of Contents
