Advertisement
Single Extender Installation
1. Using a Cat5e/6 cable (up to 100 m / 328 ft. long), connect your
powered source device (such as a PoE switch) to the "IN" port on the
unit.
2. Using another Cat5e/6 cable (up to 100 m / 328 ft. long), connect
your remote PoE-powered device (PD) (such as VoIP or IP surveillance
camera) to the "OUT" port on the unit. The LEDs will illuminate orange
for power and green for signal.
Note: Your PoE source must meet or exceed IEEE 802.3at / 802.3af standards.
Please see Maximum Supported Power table for more information.
Single Extender Installation Diagram
Single Extender Installation with Midspan Diagram
Note: Where external power is required, the power source (e.g.. midspan or PoE
injector) must be installed between the Ethernet switch (non-PoE source) and the first
NPOE-EXT-1G30WP extender.
19-02-378-9338FB-EN.indd 3
PoE
Switch
Max 100 m (328 ft.)
Midspan
Switch
(Non-PoE)
Max 100 m (328 ft.)
PoE Extender
Max 100 m (328 ft.)
PoE Extender
Max 100 m (328 ft.)
3
Camera
Camera
3/6/2019 5:13:32 PM
Advertisement
