Table of Contents
Advertisement
Installation Procedure
Setting Option
1 Remove batteries from the remote controller
2 Insert batteries and enter the option setting mode while pressing
3 Each time you press
right side is increased by "1"
4 You press
button to move to the next setteing page.
5 After setting option, press
6 Press operation button
CAUTION
• SEG1, SEG7, SEG13, SEG19 are not set as page option.
• Set the SEG1, SEG7 as ON status and SEG13, SEG19 as OFF status.
Set the each option separately since you cannot set the ADDRESS setting and indoor unit installation setting
option at the same time.
The procedure of setting option
Step 1
1 Remove the batteries from the remote controller.
2 Insert batteries while pressing
Step 2
1 Press
button to enter SEG2 value.
2 Press
button to enter SEG3 value.
Step 3
Press
button to be change to Cool mode in the ON status.
1 Press
button to enter SEG4 value.
2 Press
button to enter SEG5 value.
English
30
button, 7-seg on left side is increased by "1" and each time you press
button to check whether the option code you input is correct or not.
with the direction of remote control for set.
Operation
Button and
button and
Button.
button.
button, 7-seg on
Indication
Advertisement
Table of Contents
