Making System Connections - Episode ES-SUB-ELE8-250 Installation Manual

MAKING SYSTEM CONNECTIONS

Wiring Recommendations
For line-level connections, use high-quality, low impedance RCA cables with adequate shielding and high-quality
connectors.
Use two-conductor loudspeaker cable for high level connections that is appropriate for the installation environment
and wire length.
Audio Connections
To provide signal to the ELE subwoofer, a connection must be made from the audio source or speaker wiring. Most
home theater AV receivers and sources supply an "LFE" output for subwoofers that should be used if available.
Stereo line or speaker-level inputs from sources or speaker wiring may also be used.
CAUTION! DO NOT connect to both the line and speaker level connections at the same time. Use only line-level
connections, or only speaker-level connections.
Line-Level RCA Connections
!
WARNING! Do not connect to both the low-level RCA and high-level speaker connections. Use only one
connection method.
Left & Right
Preamp Out
OR
LFE/
SUB Out
AV Receiver/Processor
CEN RS
R
SUB LS
L
RCA Outputs
© 2018 Episode®
STATUS
OFF ON
AUTO
VOLUME
MIN MAX
PHASE
0˚ 180˚
100
CROSSOVER
50 LFE
LOW LEVEL
IN LFE
OUT
LF CF RF LR
Speaker Outputs
ES-SUB-ELE8-250
Designed and Engineered in USA
Manufactured in China
DC 5V /500mA
IN OUT
HIGH LEVEL
Optional Loop out to more subwoofers
Use same connection type as input (LFE or
L/R)
RR
page | 7
100-120V 220-240V
L
POWER
R
100-120V~60Hz 1.6A /
220-240V~50Hz 0.8A