Oki IP-7900-21 Advanced Operation Manual page 61

[Symptom D]
The ink dries too slowly.
l
(Mottling or bleeding is found.)
*1
Adjust the media advance compensation again.
*2
Note that the print speed differs depending on the mode selected.
(1) Increase the all three heaters by 5°C.
* Before starting the print, ensure that the heater temperature was decreased to the
target temperature.
(2) Set smart pass to a higher setting.
(3) Change the print mode to be slower.
(4) Print in unidirectional mode.
(5) Use the proven media.
(6) With the RIP software, apply the profile with the low ink amount ejected.
* Note that the hue may change by decreasing the ejected ink amount.
*1
*1*2
*1*2
61