Table of Contents
Advertisement
■ The heater temperature control system for printing
The Printer receives the RIP data.
(Temperature)
Printheater set temperature
Preheater set temperature
Afterheater set temperature
Standby set temperature
Ambient temperature
Display the heater control menu.
Press the HEATER button to display the heater control menu.
Button operation in the heater control menu
Right and Left buttons
Up and Down buttons
MENU button
OK button
CANCEL button
Finish displaying the heater control menu
Press the HEATER button while the heater control menu is displayed.
■ When the heater control menu display finishes automatically
H E A T E R D I S P L A Y E N D
If no button is input for 30 seconds while the heater control menu is displayed, a message HEATER DISPLAY
END appears automatically for two seconds and then the heater control menu display finishes. While this
message is displayed, no button input is effective.
70
IP-7900 Advanced Operation Guide
Print
Set temperature maintained
- The heaters become standby at the temperature below.
Preheater: 45 ºC
Printheater: 45 ºC
Afterheater: 60 ºC
However, the temperature above is lowered to the setup temperarure if the
setup temperature is lower than the standby temperature above.
Select the heater whose temperature is to be set.
Set the heater temperature.
Turns the heater ON or OFF.
When this button is pressed for 1.5 seconds while the heater control
menu is displayed, all the heaters are forcibly turned on even without print
operation. (The heating control starts.)
Pressing this button for 1.5 seconds with the heater control menu displayed
cancels the heater-on state forcibly specified by the OK button. (The
heating control stops.)
Standby time
Standby temperature maintained
Temperature control stop
(Time)
Advertisement
Table of Contents
