Chapter 3 Mechanical Disassembly And Reassembly; Equipment Needed; General Information - Acer PD100 Service Manual

Mechanical Disassembly & Reassembly
This section provides disassembly & Reassembly procedures for PD100 Micro Portable SVGA
DMD Projector. Before you begin any of these procedures, be sure to turn off the power,
computer system, and other attached devices; then disconnect the power cable from the
electrical outlet. Moreover, when you disassemble the projector, be sure to put the screws
in a safe place and separate them according to their category.

Equipment Needed

Item
Philips (+) : 107
Screw Bit
Tweezers

General Information

Before You Begin
Before proceeding with the disassembly procedure, make sure that you do the following
procedures:
1. Turn off the power of the system and all the peripherals.
2. Unplug the AC adapter and all power and signal cables from the system.
3. Anti-static wrist strap.
19
Photo
Philips (+) : 102
Hex Screw :
5mm
Screw Bit
Item
Chapter 3
Photo
Chapter 3