Chapter 3 Mechanical Disassembly And Reassembly; Equipment Needed; General Information - Acer PD726W Service Manual

Mechanical Disassembly & Reassembly
This section provides disassembly & Reassembly procedures for PD726 & PH730 DMD
Projector. Before you begin any of these procedures, be sure to turn off the power, computer
system, and other attached devices; then disconnect the power cable from the electrical
outlet. Moreover, when you disassemble the projector, be sure to put the screws in a safe
place and separate them according to their category.

Equipment Needed

Item
Philips (+) : 107
Philips (+) : 101
Screw Bit :
6.0 X 100
Long Nose
Pliers
Hexagon Keys

General Information

Before You Begin
Before proceeding with the disassembly procedure, make sure that you do the following
procedures:
1. Turn off the power of the system and all the peripherals.
2. Unplug the AC adapter and all power and signal cables from the system.
3. Anti-static wrist strap.
Chapter 3
Photo
Philips (+) : 102
Hex Screw :
5mm
Side Cutter
Pliers
Tweezers
Item
Chapter 3
Photo
20