Atag VA98211TT Operating Instructions Manual page 53

Problem
The dishes are not dry enough.
Cannot close door.
The touch buttons do not react when
pressed.
Possible causes
Drying power too low.
The dishwasher is not fully loaded.
Rinse aid needs topping up or dosage is set
too low.
3-in-1/ All-in-one detergent is used and the
setting TAB (3-in-1/ All-in-one detergent) is
activated.
The baskets are not correctly positioned.
You have pressed the touch buttons too soon
after opening the door.
Dirt on the touch buttons.
If this symbol appears on the display
the door is not open enough.
Child lock (button lock) activated.
Action
Activate the Long dry option.
Fully load the dishwasher.
Top up with rinse add or increase the rinse
aid dosage. See the sections Before washing
for the first time and Settings.
Inactivate the setting TAB (3-in-1/ All-in-one
detergent) and top up salt and rinse aid.
Open the door a little once the programme
has finished.
Check that the baskets are correctly
positioned horizontally, and that the middle
basket's water connector is in line with its
spray pipe.
Check that the dishes are not blocking the
baskets from sliding properly into place.
Wait a moment then try again.
Clean with a dry or slightly damp cloth.
Open the door until the display lights up.
Alternatively, close the door and wait 30
seconds. Then open the door again.
See the section Settings.
19