Monogram ZSA1202PSS Owner's Manual page 35

CARE AND CLEANING
REPLACING THE SURFACE LIGHT
1. To replace the surface light, first disconnect the power
at the main fuse or circuit breaker panel or unplug the
oven.
2. Remove the screw from the side of the light
compartment cover and lower the cover until it stops.
3. Be sure the bulb to be replaced is cool before removing.
Gently pull the bulb from the receptacle.
Replace with a 130 volt, 50-watt halogen bulb. Order
WB08X10051 from your GE Appliances supplier.
4. Raise the light cover and replace the screw. Connect
electrical power to the oven.
REMOVING AND CLEANING THE FILTERS
1. The metal filters trap grease released by foods on the
cooktop. They also prevent flames from foods on the
cooktop from damaging the inside of the oven.
2. For this reason, the filters must always be in place when
the hood is used. The vent filters should be cleaned
once a month, or as needed.
3. To remove, slide them to the rear using the tabs. Pull
down and out.
REPLACING THE OVEN CAVITY LAMP
1. Disconnect power at the main fuse or circuit breaker
panel.
2. Remove the top grill by removing the two screws that
hold it in place.
3. Remove charcoal filter if present. Slide the filter toward
the left and pull toward the front to remove. NOTE:
Charcoal filter is an optional kit, you may not have one.
4. Remove the screw holding the lamp shield in place.
49-7000137 Rev.0
4. To clean the vent filters, soak them and then swish
around in hot water and detergent. Don't use ammonia
or ammonia products because they will darken the
metal. Light brushing can be used to remove embedded
dirt.
5. Rinse, shake and let dry before replacing.
6. To replace, slide the filters into the frame slots on the
back of each opening. Press up and to the front to lock
into place.
5. Pull the lamp shield out. Pull the light bulb out and
replace with the 120V-130V, 20-watt halogen bulb.
Order WB25X10019 from your GE Appliances supplier.
6. Return the lamp and lamp shield to original position and
replace screw and charcoal filter.
7. Replace the grill and 2 screws. Reconnect power to the
oven
Remove screw
35