1 Safety Precautions 1.1. General Guidelines 1.3. Leakage Current Hot Check (See Figure 1.) 1. IMPORTANT SAFETY NOTICE There are special components used in this equipment 1. Plug the AC cord directly into the AC outlet. Do not use which are important for safety. These parts are marked by an isolation transformer for this check.
2 Warning 2.1. Prevention of Electrostatic Discharge (ESD) to Electrostatically Sensitive (ES) Devices Some semiconductor (solid state) devices can be damaged easily by static electricity. Such components commonly are called Elec- trostatically Sensitive (ES) Devices. The following techniques should be used to help reduce the incidence of component damage caused by electrostatic discharge (ESD).
2.3. Static Electricity Protection Measures • The laser diode in the traverse unit (optical pick-up) may break down due to potential difference caused by static electricity of clothes or human body. So, be careful of electrostatic breakdown during repair of the traverse unit (optical pick-up). 2.4.
3 Service Navigation 3.1. Service Infomation This service manual contains technical information, which allow service personnel's to understand and service this model. Please place orders using the parts list and not the drawing reference numbers. If the circuit is changed or modified, the information will be followed by service manual to be controlled with original service manual. Note: The replacement parts of this model is supplied as block unit.
3.2. Caution for DivX Please will always pass the customer “Warning for Customers Who Use the DivX Video-on-Demand content.” with the product and get it when you unavoidably exchange DIGITAL P.C.B. including FLASH ROM (When the product is exchanged, it is the same.). You must use print attached to service part (DIGITAL P.C.B.
4 Specifications Output connector: Pin jack (Y: green, P : blue, P : red) (1 system) Power supply: AC 220 to 240 V, 50/60 Hz Video performance: Power consumption: Approx. 10 W Horizontal resolution: More than 500 lines Power consumption in standby mode: Video S/N ratio: More than 53 dB Less than 1W...
6 Operating Instructions 6.1. Taking out the Disc from Drive Unit when the Disc cannot be ejected by OPEN/CLOSE button 6.1.1. When the Disc Eject can not be done. 1. Turn off the power and pull out AC cord. 2. Put the unit so that bottom can be seen. 3.
9 Disassembly and Assembly Instructions 9.1. Unit 9.1.1. Disassembly Flow Chart The following chart is the procedure for disassembling the casing and inside parts for internal inspection when carrying out the ser- vicing. To assemble the unit, reverse the steps shown in the chart below. 9.1.2.
9.1.3. Top Panel 9.1.5. Front P.C.B. and SW P.C.B. 1. Remove the 5 Screws (A). 1. Remove the 6 Screws (A). 2. Expanded the both ends of the back of the top panel in 2. Remove the Earth Plate. the direction of arrow (1), and then remove it pull up in the 3.
Page 19
9.1.7. Mechanism Unit 1. Remove the Screw (A). 2. Remove the Wire with Connector (A) and Wire with Connector (B). 3. Remove the FFC. 4. Remove the Mechanism Unit. Manual release method of tray 1. Insert paper clips, etc. into the hole on the bottom of DVD Drive, and slide the lever in the direction of arrow to eject tray slightly.
10.3. Replacement Parts List Notes: *Important safety notice: Components identified by mark have special character- istics important for safety. When replacing any of components, be sure to use only manufacture’s specified parts shown in the parts list. *All parts are supplied by PAVCSG. Safety Ref.