Advertisement
4. Orient the module so that it is facing toward the front of the FT2 series assembly as
shown in the illustration below.
5. Feed the IEC power cord attached to the module down through the appropriate
module spaces in the FT2 series assembly.
6. Slide the module into the appropriate module spaces in the FT2 series assembly.
Use the guide ribs on the front and rear of the module to help position the module in
the assembly.
FT2A-PWR-UK-1-C14
module
As of the date of manufacture, the product has been tested and found to comply with speci cations
for CE marking.
FT2A-PWR-UK-1-C14
module
IEC power
cord
Retractable lid
(located in rear
of assembly)
FT2 series
assembly (front)
Complete the Installation
1. Once all modules and plates are installed and level with their surroundings, place the
removed locking bars back into position so that the screws attached to either side of
each locking bar engage their screw holes in the FT2 series assembly.
2. Using a manual torque screwdriver set to its lowest possible setting, hand tighten
the locking bar screws until the locking bars are secured to the assembly.
CAUTION: Do not overtighten the locking bar screws.
3. Hold the magnetic bezel over the FT2 series assembly so that the lid retraction
button on the bezel is aligned with the front of the assembly.
4. Lower the bezel onto the assembly so that the lowered retractable lid ts inside the
rear opening in the bezel and the magnets snap into place against the assembly.
Refer to the illustration below.
The product warranty may be found at www.crestron.com/legal/sales-terms-conditions-warranties.
The speci c patents that cover Crestron products are listed at www.crestron.com/legal/patents.
Certain Crestron products contain open source software. For speci c information, please visit
www.crestron.com/legal/open-source-software.
Crestron, the Crestron logo, and FlipTop are either trademarks or registered trademarks of Crestron
Electronics, Inc. in the United States and/or other countries. Other trademarks, registered trademarks,
and trade names may be used in this document to refer to either the entities claiming the marks and
names or their products. Crestron disclaims any proprietary interest in the marks and names of others.
Crestron is not responsible for errors in typography or photography.
This document was written by the Technical Publications department at Crestron.
©2018 Crestron Electronics, Inc.
Crestron Electronics, Inc.
15 Volvo Drive, Rockleigh, NJ 07647
Tel: 888.CRESTRON
Fax: 201.767.7576
www.crestron.com
Bezel
opening for
retractable lid
Retractable lid
Lid retraction
button
Installation Guide - DOC. 8342A
(2052162)
07.18
Speci cations subject to
change without notice.
Advertisement
