Table of Contents
Advertisement
INTRODUCTION
Changing the door opening direction
Tools required: socket wrench No. 8, Phillips screwdriver, torx 25, Hex key No. 4 and flat
screwdriver.
The procedure to change the door opening direction opening should be carried out by at least
two persons.
1.
Remove the upper hinge cover (A) and the covering cap (G).
2.
Undo the upper hinge (B) and remove the door (C) from the lower hinge (D).
3.
Tilt the appliance backwards (make sure you do not press against the condenser unit on
the rear wall of the appliance as this may damage the cooling system), unscrew the lower
hinge (D) and the foot (E), and move them to the opposite side. Make sure the washer is
installed like it was before disassembly.
4.
Move the door hinges (F) to the opposite side, remove the door stopper S1 and attach the
door stopper S2 supplied in a bag with the instruction manual. Place the door (C) back
on the lower hinge (D).
5.
Use the screws to attach the upper hinge (B) on the opposite side.
6.
Install the upper hinge cover (A) and the covering cap (G).
7.
Place the handle (L): undo the side screws (M) and the (N) screw in the handle holder.
Take care not to damage the door. Pull the handle in the direction of the arrow. Disassemble
the handle (L): undo the screw (O), turn the handle holder (P) by 180° and reattach it using
the screw. On the opposite side of the door, remove the cover plugs (R) and place the
handle (L) in the direction of the arrow 2. Reattach the handle using the screws (M) and (N).
Place the covering plugs/caps (R) on the opposite side of the door.
EN 16
Advertisement
Table of Contents
