Package Contents; Requirements; Install The Cable Manager - StarTech.com CMVBMOD Quick Start Manual

Package contents

• 1 x cable manager (ships unassembled)
• 2 x M5x20 mm screws
• 1 x quick-start guide

Requirements

• Phillips type screwdriver
Requirements are subject to change. For the latest requirements, please visit
www.StarTech.com/CMVBMOD.

Install the cable manager

1. To attach the weighted base, select one of the segments without the mounting
plate and connect it to the weighted base.
2. Connect the other segment without the mounting plate to the segment you
connected to the weighted base.
3. Connect the remaining segment to the middle segment.
4. If you want to insert your cables before you attach the cable organizer to the desk,
thread the cables through any of the four channels in the cable organizer.
5. Position the mounting plate on the underside of a desk or table in a location that is
suitable for your setup.
6. Insert the two M5x20 mm screws through the holes in the desk attachment and into
the desk, and use a Phillips type screwdriver to tighten the screws in place.
7. To insert your cables, do one of the following:
• At the top of the cable organizer, thread the cables through any of the four
channels in the cable organizer and out the bottom of the weighted base.
• Snap the cables into any of the cable slots in each of the segments in the cable
organizer.
Instruction manual
3