Remove The Turbocharger - ABB HT563800 Operation Manual

7.3
7.3
© Copyright 2015 ABB. All rights reserved.
Removal and installation

Remove the turbocharger

Remove the turbocharger
Disconnect all exhaust gas and air lines in accordance with engine

builder's instructions.
Design with water-cooled bearing casing:
Disconnect water pipes in accordance with engine builder's

instructions.
If provided, remove hard insulation as follows:
Remove screws and plate (B) of bearing casing insulation.

Remove remaining screws of bearing casing insulation (A).

Pull bearing casing insulation up and off. Squeeze bearing casing

insulation together so that it can be removed more easily.
Unplug cable connector of speed sensor.

Fasten lifting gear to bearing casing.

If a gas outlet pipe / elbow is provided, sling lifting gear around it

additionally or fasten it lifting gear using a swivel lifting eye (C).
Unscrew fixing screws (D) on bearing casing.

Lift turbocharger off engine and set it down to one side.

Cover oil connections.

Operation Manual / TPS44-F.. - TPS61-F..
7
7.3 Page 87