Devolo 200 AVplus User Manual page 19

set up using the dLAN Configuration Wizard. Start by updating the firmware (see
'2.4.1 Firmware update') of the dLAN 200 AV adapters.
After successfully installing the devolo software, you can launch the dLAN Con-
figuration Wizard via the Start
Device Start dLAN Configuration Wizard in the devolo Informer.
Before beginning with this step, make a note of the security IDs of all existing
dLAN adapters. This unique identifier of each dLAN device is located on the label
on the housing. It consists of 4 x 4 letters separated by dashes (e.g. ANJR-
KMOR-KSHT-QRUV). Ensure that all dLAN adapters are connected to the electri-
cal wiring and computers or other network components as appropriate.
Scan for dLAN 200 AV adapter
After launching the Wizard, it initially scans for a dLAN adapter connected
directly to your computer.
Assign a network password
In this step, select a network password that will apply to all adapters in your
home network. The password must be used by all dLAN devices.
Three options are available:
Automatically generate a password
Alternatively, the Configuration Wizard can automatically generate a
password for use with your dLAN network.
Assign your own password
You can assign a password of your own.
Reset the password to the factory setting
Restore the factory default password of your dLAN adapter.
The factory default password is "HomePlugAV".
Assigning a specific password to a single adapter will exclude it from the
remaining dLAN network.
|
Security in the dLAN
Programs devolo program group and the
|
19
devolo dLAN 200 AVplus
|