Makita UM600DWAE Instruction Manual page 13

► 1 . Screws
NOTE: The shear blades can be removed without
removing the screws.
5. Remove the crank from the shear blades.
1
► 1 . Crank
NOTE: The crank may remain in the tool.
Attach the blade cover and the storage case to the
removed shear blades, and then store the blades.
Installing the shear blades
1. Prepare the crank, undercover, and new shear
blades.
1
► 1 . Crank 2. Undercover 3. Shear blades
2. Attach the blade cover to the shear blades.
1
2
3
13 ENGLISH
3. Adjust the three pins so that they are lined up on
the alignment line.
► 1 . Alignment line
4. Apply a small amount of grease to the periphery
of the crank. Attach the crank to the pins with the small
and large rounds facing down.
► 1 . Crank
5. Slide the shear blades so that the hole on the
base plate is positioned at the center of the rings of the
blades.
1
1