Table of Contents
Advertisement
PRESET - Balance
i.
Press PRESET once, LR Balance will appear.
ii.
Press ENTER once,
L-CH R-CH
0 d B
0 d B
iii.
Use the
button to lower by 1 dB increments. To raise, press
for 1 dB increments.
iv.
Press ENTER once, to lock the setting.
BAL PHASE
(Phase Selection for the Balanced Inputs and Outputs)
i.
Press PRESET twice, BAL PHASE will appear.
ii.
Press ENTER once for IN: BAL-1, Press ENTER twice for IN:BAL -2
or
iii.
Using the
iv. In the USA, most balanced products use Pin 2+. While Luxman use Pin 3 +.
v.
Press PRESET to exit.
vi.
The two balanced inputs can be set individually.
vii.
The phase on the balanced outputs can similarly be adjusted by pressing ENTER three
times, you will see
BAL OUT
3- , 2+
or
viii. Using the
REC OUT
i.
Press PRESET three times, REC OUT will appear.
ii.
Press ENTER once.
or
iii. Using the
iv. Press PRESET once to lock the setting.
buttons, you can now toggle between +3 , -2 or -3 , 2+
buttons, you can now toggle between +3 , -2 or -3 , 2+
buttons, you can now toggle between ON and OFF.
each time
12
Advertisement
Table of Contents
