Mitsubishi Electric Mr Slim PUHZ-RP50VHA4 Service Manual page 140

OPERATING PROCEDURE
12. Removing the compressor (MC)
(1) Remove the service panel. (See Photo 1)
(2) Remove the top panel. (See Photo 1)
(3) Remove the cover panel (front) fixing screws (2 for front, 5
× 12) and remove the cover panel (front). (See Photo 12)
(4) Remove the cover panel (rear) fixing screws (2 for rear, 5
× 12) and remove the cover panel (rear). (See Photo 12)
(5) Remove the electrical parts box. (See Photo 4)
(6) Remove the valve bed fixing screws (3 for front, 4 × 10) and
the ball valve and stop valve fixing screws (4 for front, 5 ×
16) and then remove the valve bed.
(7) Remove the side panel (R). (See Photo 1)
(8) Remove the separator fixing screws (3 for front, 4 × 10)
and remove the separator.
(9) Recover refrigerant.
(10) Remove the 3 points of the compressor fixing nut using a
spanner or a adjustable wrench.
(11) Remove the welded pipe of compressor inlet and outlet
then remove the compressor.
Note: Recover refrigerant without spreading it in the air.
13. Removing the power receiver
(1) Remove the service panel. (See Photo 1)
(2) Remove the top panel. (See Photo 1)
(3) Remove the cover panel (front). (See Photo 12)
(4) Remove the cover panel (rear). (See Photo 12)
(5) Remove the electrical parts box. (See Photo 4)
(6) Remove the valve bed. (See Photo 11)
(7) Remove the side panel (R). (See Photo 1)
(8) Recover refrigerant.
(9) Remove 4 welded pipes of power receiver inlet and outlet.
(10) Remove the receiver leg fixing screws (2 for front, 4 × 10).
Note: Recover refrigerant without spreading it in the air.
OCH451D
Photo 11
Valve bed
Valve bed
fixing screw
Separator
Compressor
Separator fixing screw
Photo 12
Cover panel
(Front) fixing
screws
Photo 13
Receiver leg
fixing screws
140
PHOTOS
Valve bed
fixing screws
Power
receiver
Compressor fixing
nut
Cover panel
(Rear)
Cover panel
(Front)
Inlet
Outlet
Power
receiver
Receiver
leg