Starting A Washing Program - Danby DDW611WLED Owner's Use And Care Manual

Lave-vaisselle
Hide thumbs Also See for DDW611WLED:
Table of Contents

Advertisement

Available languages

Available languages

Operating Instructions

STARTING A WASHING PROGRAM

CHANGING THE
PROGRAM
FORGOT TO ADD A
DISH?
AT THE END OF THE
WASH CYCLE
You can modify the washing program when the dishwasher just runs for a
short time. Otherwise, the detergent may have already been released,
and the appliance may have already drained the wash water. If this is the
case, the detergent dispenser must be refilled.
To change the washing program, press the start/reset button to pause the
working program, and then press the program button for more than 3 sec-
onds and choose the program you need then the washing cycle resumes.
NOTE: If you open the door during washing, the machine will pause.
When you close the door and press the start/reset button the washing
resumes 10 seconds after you close the door.
The lights show the state of the dishwasher:
a) All phase lights off-----------------------------------On stand by
b) The display has no blinking-----------------------Being paused
c) The display is blinking------------------------------Running
A forgotten dish can be added any time before the detergent
cup opens.
1
Press the start/reset button to pause the cycle.
2
Open the door a little to stop the washing.
3
After the spray arms stop working, you can open the door completely
4
Add forgotten dishes.
5
Close the door
6
Press the start/reset button, the dishwasher will run after 10 seconds.
When the working cycle has finished, the buzzer will sound for 8 seconds,
then stop. Turn off the appliance using the ON/OFF button, shut off the
water supply and open the door of the dishwasher. Wait a few minutes
before unloading the dishwasher to avoid handling the dishes and utensils
while they are still hot and more susceptible to breakage. They will also
dry better.
• Switch off the dishwasher
All the phase lights are off!
1.Switch off the dishwasher by pressing the ON/OFF button.
2.Turn off the water tap!
• Open the door carefully
Hot dishes are sensitive to knocks. The dishes should therefore be
allowed to cool down around 15 minutes before removing from the appli-
ance. Open the dishwasher's door, leave it ajar and wait a few minutes
before removing the dishes. his way they will be cooler and the drying will
be improved.
• Unloading the dishwasher
It is normal that the dishwasher is wet inside.
It is dangerous to open the door when washing, because the hot
water may scald you.
13
WARNING

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents