Display Elements And Symbols - VOLTCRAFT VC271 TRMS Operating Instructions Manual

8. Display elements and symbols

The following symbols and letters appear on the device/display. Other symbols may appear on the display (display
test), but these have no function.
1 True RMS measurement
2 Delta symbol for relative measurement
(= reference measurement)
3 Mega symbol (exp.6)
4 Kilo symbol (exp.3)
5 Ohm (unit of electrical resistance)
6 Hertz (unit of frequency)
7 Nano symbol (exp.-9)
8 Milli symbol (exp. -3)
9 Volt (unit of electrical voltage)
10 Micro symbol (exp. -6)
11 Ampere (unit of electrical current)
12 Farad (unit of electrical capacity)
13 Automatic power-off function is enabled
14 Measured value
15 Diode test symbol
16 Symbol for the acoustic continuity tester
17 Low impedance symbol
18 Terminal assignment indicator
19 Automatic range selection is enabled
20 Battery status indicator
21 Hold function is enabled
22 Direct current symbol ( )
23 P olarity indicator for current flow direction
(negative pole)
24 Alternating current symbol ( )
25 Warning symbol for dangerous voltage
43