Advertisement
Fireplace Installation
bracket.
5. Adjust the wall-mounting
bracket so the bubble on the
level is centered between the
two black lines.
6. Mark 3 other mounting screw
locations, on the wall, ensur-
ing that the wall bracket stays
level.
7. Install the supplied wall an-
chors on the drywall marked
locations by placing a #2 Phil-
lips screwdriver into the recess
of the anchor.
8. Press the anchor into the wall
in the desired marked posi-
tion while turning the anchor
clockwise until it is flush with
the wall.
9. Insert the wall anchor screws
through the wall bracket and
thread into the wall anchors.
Tighten the screw (Figure 4).
Figure 4
Screw
Wall
bracket
Wall anchor
Figure 5
10. Install the remaining screws
through the bracket and into
the wall studs as required.
!
NOTE: At least two of the
mounting screws must be in-
stalled into a wall stud.
11. Mount the unit on the wall,
so that the tabs on the wall
bracket have been inserted
into the slots on the back of
the firebox, as shown. (Figure
5)
12. Carefully pour and evenly dis-
tribute the supplied glass rock
media in the Media tray of the
firebox (Figure 6).
13. Hang the front glass assembly
on the mounts of the firebox
and secure the glass onto the
unit by installing the retaining
screws (Figure 7).
14. Excess electrical cord can be
9
Advertisement
