Table of Contents
Advertisement
Quick Links
Gas Grill Models: C10-601T-CSA, C10-603T-CSA
For questions regarding performance, assembly,
operation, parts, or returns, contact the experts
at MAGMA by calling (562) 627-0500
For questions regarding performance,
assembly, operation, parts, or returns,
contact the experts at MAGMA directly
7:00 a.m. - 5:00 p.m. Pacific Time Monday thru
1 - 800 - 86 - MAGMA
Friday or e-mail us at mail@MagmaProducts.com
IMPORTANT, read these instructions carefully before use. Familiarize yourself with the appliance
before connecting it to its gas container. Keep these instructions for future reference.
OWNER'S MANUAL
by calling TOLL FREE
7:00 a.m. - 5:00 p.m.
Pacific Time Monday thru Friday
or e-mail us at
magmamail@aol.com
TM
Advertisement
Table of Contents
Related Manuals for Magma C10-601T-CSA
Summary of Contents for Magma C10-601T-CSA
- Page 1 MAGMA directly 7:00 a.m. - 5:00 p.m. Pacific Time Monday thru by calling TOLL FREE 1 - 800 - 86 - MAGMA Friday or e-mail us at mail@MagmaProducts.com 7:00 a.m. - 5:00 p.m. Pacific Time Monday thru Friday or e-mail us at magmamail@aol.com...
-
Page 2: Important Safety Warnings
• USE PROPANE GAS ONLY. FUEL STORAGE SHOULD BE IN COMPLIANCE WITH THE NATIONAL FIRE PROTECTION ASSOCIATION (NFPA) STANDARD 58 LIQUID PETROLEUM GAS CODE AND OCCUPATIONAL HEALTH AND SAFETY ADMINISTRATION (OSHA) STANDARD 29 CFR 1910.101 • FOR NATURAL GAS APPLICATION CONTACT MAGMA. • ALWAYS LIGHT GRILL WITH LID OPEN. • NEVER LEAVE HOT GRILL UNATTENDED. -
Page 3: Installation Instructions
MOUNT HARDWARE See Magma website Fasteners are supplied for Single Mount for replacement part numbers mounting option. See Magma Website for and valve applications. mount selection. www.MagmaProducts.com Thermometer... -
Page 4: Operating Procedures
Medium ALWAYS OPERATE WITH GREASE TRAY IN PLACE. WARNING: Do not overheat grill. Magma Grills do not require pre-heating. Stainless Steel loses anti-corrosive characteristics when subjected to extreme heat. Most grilling is done on low temperature with the lid closed. If medium or high heat is required, grill with lid open. - Page 5 ELECTRODE SPARK ADJUSTMENT CAUTION: Spark can cause small shock. Do not leave fingers on or near electrode wire while engaging igniter. • Electrode wire should be approximately 1/8” from gas exit hole in burner. Carefully adjust wire if required. DISASSEMBLY & RE-ASSEMBLY •...
-
Page 6: Maintenance
Control Valve - All valves are set and tested at our factory. Do not attempt to adjust or disassemble the valve in any way. Call Magma if you suspect it is not adjusted properly. Clean valve with a cloth and remove any debris obstructing the orifice. -
Page 7: Troubleshooting Guide
• Magma on-board CNG (natural gas) valves allow Magma grills to be installed to an existing on-board, pre-regulated low pressure CNG (natural gas) system. • Use only Magma Type 4 Low Pressure CNG (natural gas) control valves. Visit out website at MagmaProducts.com to view valve application guide. See your local dealer for proper hose and fittings. -
Page 8: Limited Warranty
Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you. Neither Magma dealers, nor the retail establishment selling this product has any authority to make any warranties or to promise remedies in addition to or inconsistent with those stated above.
Need help?
Do you have a question about the C10-601T-CSA and is the answer not in the manual?
Questions and answers