Table of Contents
Advertisement
Preparation/Installation of the hot tub
2 2
Preparation for the interior hot tub installation
If the hot tub is installed in an interior space, it is necessary to comply with safety
instructions. The basic safety requirements are mainly non-skid floors and drainage in
the place of the installation in case of a water overflow. It is also crucial to keep in mind
that the humidity around the hot tub will rise and can damage surrounding electric ap-
pliances. Therefore we recommend customizing the place of the installation according
to these conditions. The hot tub should be accessible from all sides for future repair
services. If it is not sufficiently accessible during the guarantee period, the owner has
a duty to ensure the access.
2 3
Preparation for the exterior hot tub installation
If the hot tub is installed in an exterior space, it is necessary to comply with safety
instructions. The basic safety requirements are mainly non-skid floors and water drain-
age in case of a rainfall or water overflow from the hot tub. Therefore we recommend
customizing the place of the installation according to these conditions.
3
Installation of the hot tub
Warning: connection to electricity must be done according to norms valid in
Czech Republic ČSN 33 2000-7-701
3 1
General information
We strongly recommend you to hire professionally trained and qualified technicians
for the process of installation. If you decide to install the hot tub by yourself, please
abide by the following instructions.
a)
Carefully remove all the packaging material from the hot tub and position the hot
tub on a beforehand selected place of installation.
b)
Demount the front panel on the side of the hot tub control panel. Demount the
upper cover of an electrical wiring under which you can find a residual current
device, a ground fault circuit interruptor (if it is part of the hot tub equipment)
and a ground staple. The connection itself must be done by a person with an
expert qualification.
c)
Every hot tub is tested in real life conditions during the production process,
therefore there is a possibility some technical parts of the hot tub have remained
slightly dirty. We recommend you to clean the surface of the hot tub using a
suitable method; lukewarm water works best for this purpose. Clean the surface
using a soft cloth only. Don't use any rough abrasive means and cloths which could
permanently damage the surface of the hot tub. If you decide to use a generic
cleaning detergent, it cannot be aggressive towards the hot tub surface.
5
Advertisement
Table of Contents
