Table of Contents
Advertisement
Quick Links
ZA-723
TWO-WAY RADIO
UHF HANDHELD FM TRANSCEIVER
USERS MANUAL
Long Range
Robust & Durable
Li-ion Battery
Desktop USB Charger
Loud Clear Audio
16 Channels
Thank you for purchasing the Zartek ZA-723 Portable Two Way Radio. This radio is
easy to use and gives you reliable and clear communication. The ZA-723 UHF
transceiver is approved by ICASA to operate at 0.5W on both license-free bands
namely 464 MHz consisting of 5 frequencies and 446MHz consisting of 8
frequencies.
Please read this manual carefully before using the radio. The information presented
here will ensure that you get maximum performance and functionality from the radio.
There are also important battery and charging maintenance procedures.
High strength materials and quality components have been used in the manufacture
of this two-way radio to give many years of product use. It is designed for every day
security or general use both indoors and outdoors. The ZA-723 radio is durable and
easy to operate.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Zartek ZA-723
Summary of Contents for Zartek ZA-723
- Page 1 Loud Clear Audio 16 Channels Thank you for purchasing the Zartek ZA-723 Portable Two Way Radio. This radio is easy to use and gives you reliable and clear communication. The ZA-723 UHF transceiver is approved by ICASA to operate at 0.5W on both license-free bands namely 464 MHz consisting of 5 frequencies and 446MHz consisting of 8 frequencies.
-
Page 2: Warranty
If the product has been tampered with in any way, the warranty shall be considered null and void. For any queries, email info@zartek.co.za Safety Information Study this manual carefully to understand your transceiver well. - Page 3 (1a-5a). Select the same channel on any ZA-723 radio to communicate. Compatibility: The ZA-723 is factory programmed to be directly compatible with all 16 channels on the TX-8, ZA-720 and ZA-721 radios and channels 1 to 12 on the ZA-748, ZA-725 and ZA-758 and the first 8 channels on the ZA-708 if they are set to factory programming.
-
Page 4: Battery Information
Battery Information Initial Use New batteries are not charged fully in the factory. Please charge the battery for 4 hours at least before first use. This initial charge pre-conditions the battery for full capacity. Failure to charge fully may shorten the life span of the battery. Recharge the battery immediately once it goes flat as it could get damaged if left very flat for long periods. -
Page 5: Included Items
Carefully unpack the transceiver. We recommend that you identify the items listed below before discarding the packing material. If any items are missing or have been damaged during shipment, contact the supplier immediately. For optional accessories, please visit our website www.zartek.co.za INCLUDES • •... -
Page 6: Getting Started
Getting Started Install & Remove the belt clip Whilst the battery is detached from radio, insert the belt clip into the top back groove. To remove the belt clip, first detach the battery pack and then slide belt clip off. Install &... -
Page 7: Basic Operation
Note: 1. Make sure the radio is switched off during charging or the charging time will be longer and number of possible battery charge cycles reduced. 2. Li-ion batteries do not have memory so they can be recharged at any time. There are a limited number of charge cycles that the battery can handle, typically 500-700 times. -
Page 8: Programming (Optional)
Range will depend on the type of terrain that you are communicating across. The ZA-723 uses the UHF (Ultra High Frequency) band and will be subject to similar obstacle interference as cellular phones. The radio works indoors as well as outdoors. - Page 9 Install the software on to a PC by following the installation steps. Once installation is finished, an icon called “ZA-723 User PC Software” will appear on the screen. Connect the USB cable to the PC and plug-in the twin connector into the speaker/microphone jack on the side of the radio.
- Page 10 There are 38 CTCSS standard tones (1-38) plus 12 extra QT tones. The 38 tones are common on other 446 MHz radios such as the Zartek RX-8, COM8 or PT8. If the tone is left “OFF”, the frequency is left “open” to receive communication from any tone, but your transmitter will not be decoded by a radio with a tone.
- Page 11 Factory programmed on TOT 180s VOX (Voice-operated Transmission) The ZA-723 has a multi-level sensitivity built-in VOX function. You can enjoy talking and listening without pressing PTT key as transmit is automatically activated by sound. This turns your radio into hands-free “walk & talk” when used with a headset.
- Page 12 A VOX delay of 0.5 to 3 seconds can also be set for convenient use. Once the radio detects sound and begins transmitting, the radio will continue sending for this time delay period even if sound is softer than threshold. Note that VOX function is only for channels 1 –...
-
Page 13: Optional Accessories
Optional Accessories HEADSETS (use with PTT or VOX) GE-252 Earphone speaker with in-line PTT microphone GE-259 Lapel speaker microphone for vehicle & security use GE-266 Acoustic eartube speaker with microphone for discrete communication GE-272 Single Muff Earpiece Boom microphone with PTT GE-273 Heavy Duty D-Cup high volume speaker with mic. -
Page 14: Specification
Specification Specifications may be revised without notice due to technical improvements. GENERAL Frequency Range 446MHz & 464MHz Channel Capacity Frequency Spacing 12.5kHz Working Voltage 3.7V ±5ppm Frequency Stability -10℃~ ＋50℃ Operating Temperature Range Dimension incl Antenna (L×W×H) 165mm×55mm×32mm Weight (including Antenna and Battery) 160g Battery Capacity 1200mAH...
Need help?
Do you have a question about the ZA-723 and is the answer not in the manual?
Questions and answers